Thread Info
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Internal webservices not reachable from outside when using HA

rprengel
Hallo,
I configured  2 internal Webserver to be useable by dyndns Adresses from outside using the waf. Everythings works fine until I start a second node in my ha configuration.
After starting user from outside get only a service down message page from the astaro. 
I ve no idea what is happening.
Thanks for hints.

Raf


This thread was automatically locked due to age.
  • 0
    Moved thread to correct forum.

    until I start a second node in my ha configuration
    Active-active or active-passive?  Are the nodes synced?
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
    • 0 in reply to Scott_Klassen
      Moved thread to correct forum.  Active-active or active-passive?  Are the nodes synced?
        
      Hallo,
      Active Passive and nodes are synced.
      It worked for some hours with HA after configuring the pathes but this morning same problem as before. I m using 2 virtuell Astaros as HA. Perhaps a performance problem?

      Ralf
      • 0 in reply to rprengel
        Hallo,
        Active Passive and nodes are synced.
        It worked for some hours with HA after configuring the pathes but this morning same problem as before. I m using 2 virtuell Astaros as HA. Perhaps a performance problem?

        Ralf


        ok,
        seems to bee solved.
        Esx Networkinterafces promicouse mode was off.
        cc set ha advanced virtual_mac was configured again.

        Thanks for the hints.

        Ralf
    Unfiltered HTML