This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Internal webservices not reachable from outside when using HA

Hallo,
I configured 2 internal Webserver to be useable by dyndns Adresses from outside using the waf. Everythings works fine until I start a second node in my ha configuration.
After starting user from outside get only a service down message page from the astaro.
I ve no idea what is happening.
Thanks for hints.

Raf

This thread was automatically locked due to age.

0 Scott_Klassen over 9 years ago

Moved thread to correct forum.

until I start a second node in my ha configuration
Active-active or active-passive? Are the nodes synced?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 rprengel over 9 years ago in reply to Scott_Klassen

Moved thread to correct forum. Active-active or active-passive? Are the nodes synced?

Hallo,
Active Passive and nodes are synced.
It worked for some hours with HA after configuring the pathes but this morning same problem as before. I m using 2 virtuell Astaros as HA. Perhaps a performance problem?

Ralf
Cancel
Vote Up 0 Vote Down

Cancel
0 rprengel over 9 years ago in reply to rprengel

Hallo,
Active Passive and nodes are synced.
It worked for some hours with HA after configuring the pathes but this morning same problem as before. I m using 2 virtuell Astaros as HA. Perhaps a performance problem?

Ralf

ok,
seems to bee solved.
Esx Networkinterafces promicouse mode was off.
cc set ha advanced virtual_mac was configured again.

Thanks for the hints.

Ralf
Cancel
Vote Up 0 Vote Down

Cancel