This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Setting Virtual Webserver to specific IP

I have an interface DMZ that is configured as a /28 subnet so it has 14 usable IP addresses. This was provided to us by our ISP.

When I go to setup a virtual webserver, I can pick the DMZ interface but that virtual webserver only listens to the first IP address in the /28 network.

How do I specify which IP address the virtual webserver will listen on? My only option seems to be able to pick the interface.

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

The Interface definition will only use the first address. Did you setup the other thirteen addresses at Interfaces & Routing > Interfaces > Additional Addresses for use?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 9 years ago

The Interface definition will only use the first address. Did you setup the other thirteen addresses at Interfaces & Routing > Interfaces > Additional Addresses for use?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data