PRTG SNMP monitoring on UTM9

Question

Hi All, 
 i have PRTG configured with the MIB file i found online (on this forum) 
 i was wondering, for the moment i'm not able to monitor my traffic on the eth ports, that is actually the most important thing for me. 
 my knowledge of SNMP is limited, is there anyone that could give me a direction on how to get this working ? 
 i noticed for XG some people really dig into it and found it eventually , i'm wondering if there are some that do the same for UTM9 
 
 thanks in advance

Wesley Ramon · Accepted Answer

I will mark this post as answered , i did some digging around in PRTG and found a specific default SNMP sensor for reading traffic , this one can read my eth ports (in / out / total) so i have everyrhing that i needed now. 
 maybe this could help someone else. 
 
 Regards

Vivek Jagad · Answer

Hello Wesley Ramon , 
 
 Download PRTG_Sophos_20170112.zip 
 Extract all files into the folder of your your PRTG installation under %programfiles%PRTG Network Monitor . 
 In PRTG, create a new device . 
 Navigate to the settings page of the device . 
 Choose Device Type > Sensor Management > Automatic sensor creation using specific device template(s) > Sophos UTM9 and let PRTG create the Sophos UTM sensors for you. For newer versions, please right-click the device within your device tree instead and choose "Auto-Discovery > Run Auto-Discovery with Template" and select the device template "Sophos UTM9" here. 
 Enjoy monitoring your Sophos UTM device!

PRTG SNMP monitoring on UTM9

Top Replies