Sophos SG210 2 WAN Interfaces Failover

Hi Patrick,

Thank you for contacting Sophos Community, you may refer to the link below:

Configuring gateway load balance and Failover:

docs.sophos.com/.../index.html

Hi, 

sorry for my delayed answer. I only have the option uplink balancing . Nothing Else. Any advise?

@Erick: This is SG-UTM, not Sophos Firewall (XG/XGS)

@ Patrick

On UTM, you have Uplink balancing and with the list at „Active Interfaces“ you can define the order and give them a weight with that small „tool“ Button at the top of the list. In Addition you have Multipath rules.

@Everyone

Apologies about that and thank you for correcting

Hello Patrick Derlet,

Thank you for reaching out to the community, please refer the following KBA - Uplink Balancing and Multipath rules: https://support.sophos.com/support/s/article/KB-000034635?language=en_US

Hi, 

Okay, then I still adjust the weighting. Sorry for the further question - but ... That now both lines are under active, is now correct or? Or must the slower line be under standby interfaces? If so, is the line still controlled via Multiplath?

Both interfaces are active, then.