I have a Sophos SG210 with 2 WAN interfaces configured. If one line fails, the system should automatically switch to the other interface. When the defective line is working again, the primary line should be activated again. This is a slow connection and a fast connection.
Thanks a lot !
Thank you for contacting Sophos Community, you may refer to the link below:
Configuring gateway load balance and Failover:
Erick JanCommunity Support Engineer | Sophos Technical SupportSophos Support Videos | Product Documentation | @SophosSupport | Sign up for SMS AlertsIf a post solves your question use the 'Verify Answer' link.
Okay, then I still adjust the weighting. Sorry for the further question - but ... That now both lines are under active, is now correct or? Or must the slower line be under standby interfaces? If so, is the line still controlled via Multiplath?
Both interfaces are active, then.
Mit freundlichem Gruß, best regards from Germany,
New Vision GmbH, GermanySophos Silver-Partner
If a post solves your question please use the 'Verify Answer' button.