Hi
I need to add few reds but, some sites have same subnet and we cannot change it.
HQ : 172.16.1.1 /24 network
SIte 1 : 192.168.1.0/24 network
SIte 2 : 192.168.1.0/24 network
SIte 3 : 192.168.1.0/24 network
SIte 4 : 192.168.1.0/24 network
SIte 5 : 192.168.1.0/24 network
SIte 6 : 192.168.1.0/24 network
Any idea how can I set up the RED device using (NAT or SNAT) behind these SD-RED 20?
Thanks
Hi cyberguy ,
Thank you for reaching out to the community, Refer - Sophos Firewall: How to configure firewall rule and NAT rule on Sophos Firewall
Additionally, if LAN and RED are on the same network then you can refer - Sophos Firewall: Configure LAN and RED devices to be on the same network
You can refer the docs below:
> Create a source NAT rule - Sophos Firewall
> Add a NAT rule - Sophos Firewall
Thanks & Regards,
_______________________________________________________________
Vivek Jagad | Team Lead, Technical Support, Global Customer Experience
Log a Support Case | Sophos Service Guide
Best Practices – Support Case | Security Advisories
Compare Sophos next-gen Firewall | Fortune Favors the prepared
Sophos Community | Product Documentation | Sophos Techvids | SMS
If a post solves your question please use the 'Verify Answer' button.
I am not sure this is the right solution - because some clients will have the same IP - and bridging the interfaces would create chaos.