This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DHCP relay additional address

I've got a UTM 9.7 appliance acting as default gateway with eth0 192.168.1.0/24 and I'm trying to build a seperate subnetz 192.168.2.0/24 in the same default vlan to create another DHCP pool.

DHCP requests are getting relayed to an internal Windows DHCP in the 192.168.1.0/24 subnet.

On the virtual appliance i've implemented those scenarios by adding an extra interface but in this case all interfaces are currently used.

I've added an addional address on the eth0 LAN interface, created FW-Rules between those subnets and added a static routing but without success.

The clients are not getting an IP from the Windows DHCP Server.

Could it be that the UTM is not able distribute the DHCP broadcast via the addional address? In that case I would extend the existing subnet from /24 to /23 to get this running.



This thread was automatically locked due to age.