This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Install problems: UTM 9.4 on Mintbox 2

Hi,

I'm trying to install UTM 9.4 Home on a Mintbox 2. http://www.fit-pc.com/web/products/mintbox/mintbox-specifications/

It has the standard config except I've replaced the HDD with a brand new Kingston 128GB SSD.

I'm trying to install from a USB-stick, and I've tried to follow these instructions to the dot: https://community.sophos.com/products/unified-threat-management/f/hardware-installation-up2date-licensing/27887/usb-stick-install-solved

The installation goes on for a while but fails with without a specific error message. It just says 'installation failure' and gives the option to write a log file to the USB-drive, which I have done.

Please see install.zip that I wrote to the memory-stick when the installation failed. This is apparently a file that could contain vital info and is an option that you choose to perform when the installation fails.

install.zip

So, I need some help to overcome this, please :-)

This thread was automatically locked due to age.

Parents

0 Sven David Hildebrandt over 7 years ago

So, noone has any clue here? I can't raise a ticket with Sophos since this is a free tool, so I'm dependent upon the community here :-)
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 7 years ago in reply to Sven David Hildebrandt

Clue, might be ethernet card, I can only see one on one box. The specifications didn't show network connectivity. The site is very slow. You will need two NICs minimum, not USB connected.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 7 years ago in reply to rfcat_vk

Wrong answer, had to switch to the UTM link to get full access to the site. The box has 2 NICs. Does the box support the HPT timer?

The XG insisted that the site had a coding problem and would not download the pages.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Sven David Hildebrandt over 7 years ago in reply to rfcat_vk

I'm not sure about the HPET timer, but the hardware is fairly modern. You can read about it on the link in my original post. The box has two built-in NICs, one Intel and one Realtek. I did not have a network cable attached in any of them during the install attempt.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Sven David Hildebrandt over 7 years ago in reply to rfcat_vk

I'm not sure about the HPET timer, but the hardware is fairly modern. You can read about it on the link in my original post. The box has two built-in NICs, one Intel and one Realtek. I did not have a network cable attached in any of them during the install attempt.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data