Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 6 subscribers
  • Views 5671 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Install problems: UTM 9.4 on Mintbox 2

Sven David Hildebrandt

Hi,

I'm trying to install UTM 9.4 Home on a Mintbox 2. http://www.fit-pc.com/web/products/mintbox/mintbox-specifications/

It has the standard config except I've replaced the HDD with a brand new Kingston 128GB SSD.

I'm trying to install from a USB-stick, and I've tried to follow these instructions to the dot: https://community.sophos.com/products/unified-threat-management/f/hardware-installation-up2date-licensing/27887/usb-stick-install-solved

 

The installation goes on for a while but fails with without a specific error message. It just says 'installation failure' and gives the option to write a log file to the USB-drive, which I have done.

 Please see install.zip that I wrote to the memory-stick when the installation failed. This is apparently a file that could contain vital info and is an option that you choose to perform when the installation fails.

install.zip

 

So, I need some help to overcome this, please :-)



This thread was automatically locked due to age.
Parents Reply
  • 0 in reply to Sven David Hildebrandt

    Clue, might be ethernet card, I can only see one on one box. The specifications didn't show network connectivity. The site is very slow. You will need two NICs minimum, not USB connected.

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

Children
  • 0 in reply to rfcat_vk

    Wrong answer, had to switch to the UTM link to get full access to the site. The box has 2 NICs. Does the box support the HPT timer?

    The XG insisted that the site had a coding problem and would not download the pages.

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    I'm not sure about the HPET timer, but the hardware is fairly modern. You can read about it on the link in my original post. The box has two built-in NICs, one Intel and one Realtek. I did not have a network cable attached in any of them during the install attempt.

Unfiltered HTML