Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 8 replies
  • Answers 2 answers
  • Subscribers 40 subscribers
  • Views 2856 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Configure two WAN for WIFI zone

Authorized

Added second WAN zone network port5

ipv4 192.168.101.2/27
gateway ip 192.168.101.1 


SSID new network 

DHCP

Firewall Rule

WAN link manager information

able to connect Tablet to Wifi and i get DCHP release

result block firewall rule not matched. if i remove port 5 and select any the traffic goes from port 2 original WAN zone interface which i do not want to use at all.

I must create new wifi and route the traffic on separate WAN interface 

I would appreciate some help and confirm what is wrong with my configuration.

Thank you



This thread was automatically locked due to age.
Parents
  • 0

    This is a bit confusing. Are you trying to configure two APs to go to two different WANs? Or are you trying to have your current WiFi zone (which might have multiple APs, not sure if that's part of your use case) load balance across two WANs? Or failover? Or to go to the second WAN and ignore the original WAN? (In the last case, using one WAN for WiFi and the other WAN for non-WiFi traffic?)

Reply
  • 0

    This is a bit confusing. Are you trying to configure two APs to go to two different WANs? Or are you trying to have your current WiFi zone (which might have multiple APs, not sure if that's part of your use case) load balance across two WANs? Or failover? Or to go to the second WAN and ignore the original WAN? (In the last case, using one WAN for WiFi and the other WAN for non-WiFi traffic?)

Children
  • 0 in reply to Wayne Folta

    SSID/networks are allowed limited to 8 ( the 8th new network SSID must not use default WAN ISP XXXX )
    Looking to configure SSID network with its own DHCP with a second WAN interface that uses different ISP vendor

    suspecting firewall rule that is not liking destination network port5 ( WAN2 )
    troubleshooting steps:

    - Connected to the SSID
    - Getting DCHP addrr
    - Ping gateway and interface 192.168.101.1 <-->  192.168.101.2 =ok

    switching destination networks port5 to any all traffic route out trough defautl WAN interface but adding port5 WAN2 no traffic


    what am trying to achieve is to have indepent isolate New WIFI Network ---->  secondary WAN

    Thank you

Unfiltered HTML