Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 1 subscriber
  • Views 1635 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WEB Cid. Message Relay via ISA 2006

StarRefrigerati

I was wondering if anyone could assist me on publishing an internal web cid on ISA 2006 Server for remote clients to update from

I would also be looking for help on using Message Relay to allow remote clients to contact the internal enterprise console if possible. I have seen the article on using a DMZ, but I dont have a DMZ here Thanks in advance

:2224


This thread was automatically locked due to age.
Parents
  • 0

    You could use an updating policy with the primary location UNC (which would be used when the clients are "inside" or connected via VPN) and the secondary http (although http might be faster than UNC via VPN).

    If you configure RMS in your WebCID to use the Message Relay once the clients have updated from it they will always use the relay (whether outside or inside). Assuming the ISA can also be used from the inside this should not be a problem. 

    "Message Routing" can be confusing at first because it involves also configuring a CID and configuring RMS. The former is also used when you want to install default policies (e.g. for unmanaged computers) or want to use scanning options which can't be set using the console the latter e.g. of you want to "move" clients from one management server to another.

    Christian 

    :2236
Reply
  • 0

    You could use an updating policy with the primary location UNC (which would be used when the clients are "inside" or connected via VPN) and the secondary http (although http might be faster than UNC via VPN).

    If you configure RMS in your WebCID to use the Message Relay once the clients have updated from it they will always use the relay (whether outside or inside). Assuming the ISA can also be used from the inside this should not be a problem. 

    "Message Routing" can be confusing at first because it involves also configuring a CID and configuring RMS. The former is also used when you want to install default policies (e.g. for unmanaged computers) or want to use scanning options which can't be set using the console the latter e.g. of you want to "move" clients from one management server to another.

    Christian 

    :2236
Children
No Data
Unfiltered HTML