Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 14 replies
  • Subscribers 1 subscriber
  • Views 3927 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Enterprise Console Upgrade from 3.x to 4.5 accross domains

IT-Monkey

Mornin all,

I have spent quite a bit of time reading through the migration guides found in the knowledge base and its covered pretty much everything.

My only question left is regarding the requirement for the new and old server to be on the same Domain.

Is it at all possible to migrate to a different domain?  (the end points are going to remain on the old domain for the time being)

Thanks

Mark

:6785


This thread was automatically locked due to age.
Parents
  • 0

    "If you don't care about the clients'  "historical data" and have only a few groups and policies you could also simply set up SEC4.5 on the new server and skip the SEC migration. You'd just create the required groups and policies, then change the updating policies on the old server to use the new CIDs and wait for the clients to switch over."

    Would like to obtain more information on this process. Looking to move our facility from SECv3.1.0.246 to SECv4.5. No migration needed @ this time. Server side seems straight forward... install SEC4.5 on a new 2003 server. What is the most effective means to reconfigure my workstations so they listen to, and are managed from, the new SEC4.5 server.

    Thanks

    :6863
Reply
  • 0

    "If you don't care about the clients'  "historical data" and have only a few groups and policies you could also simply set up SEC4.5 on the new server and skip the SEC migration. You'd just create the required groups and policies, then change the updating policies on the old server to use the new CIDs and wait for the clients to switch over."

    Would like to obtain more information on this process. Looking to move our facility from SECv3.1.0.246 to SECv4.5. No migration needed @ this time. Server side seems straight forward... install SEC4.5 on a new 2003 server. What is the most effective means to reconfigure my workstations so they listen to, and are managed from, the new SEC4.5 server.

    Thanks

    :6863
Children
No Data
Unfiltered HTML