This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP10 performance - throughput

I rebuilt one of my UTMs because I could not find a rule that not working correctly.

Enabled the AP10, did all the magic in ssh and only increased the connection speed to 72mb/s even though the specifications shows 150mb/s. Not sure about 150mb/s on a device that has a LAN interface of 100mb/s?

Now I have seen faster connections in the past, but not with any of the most recent UTM software releases. Am I daydreaming?

Your thoughts and suggestions appreciated.



This thread was automatically locked due to age.
Parents Reply
  • In actual practice that connect speed is only between the AP and mac, so the lan speed allowing security encryption and handshaking is more likely to be around 90-100mb/s mark.

    So,still no answer on how I get the APs to connect at 150mb/s. I have seen it done in the past on my networks.

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

Children
No Data