This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP10 performance - throughput

I rebuilt one of my UTMs because I could not find a rule that not working correctly.

Enabled the AP10, did all the magic in ssh and only increased the connection speed to 72mb/s even though the specifications shows 150mb/s. Not sure about 150mb/s on a device that has a LAN interface of 100mb/s?

Now I have seen faster connections in the past, but not with any of the most recent UTM software releases. Am I daydreaming?

Your thoughts and suggestions appreciated.

This thread was automatically locked due to age.

0 sachingurung over 8 years ago

Hi,

It is tough to consider that 100BASE TX, will provide a throughput of 150mbps! Where did you checked the specifications that shows 150mb/s?

Thanks

Sachin Gurung
Team Lead | Sophos Technical Support
Knowledge Base | @SophosSupport | Video tutorials
Remember to like a post. If a post (on a question thread) solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel
0 IanMorehouse over 8 years ago in reply to sachingurung

anyone of the websites that shows specifications for an AP10 including the Sophos AP10 manual as written and published by Sophos. If you like I can post screen shot of the manual or post a link to the manual.

Ian,

home UTM 9.x running in ESXi 6 e3-1275v2

AP55c and AP10 (courtesy Astaro)

Three other UTMs, SUM and SFM in hibernation

XG 15.x MR3 in hibernation
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 8 years ago in reply to IanMorehouse

Hi Ian,

try this url

https://www.sophos.com/en-us/medialibrary/PDFs/documentation/sophoswirelessoien.pdf

it has all the good information on an AP10.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 8 years ago in reply to rfcat_vk

In actual practice that connect speed is only between the AP and mac, so the lan speed allowing security encryption and handshaking is more likely to be around 90-100mb/s mark.

So,still no answer on how I get the APs to connect at 150mb/s. I have seen it done in the past on my networks.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel