This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Configure AP55s with 2 SSIDs and 2 VLANs

 I have some AP55s connected to a XG230.

They are broadcasting 1 SSID, Bridge to AP LAN, with no problems

I would like them to broadcast another SSID (called guest) on a seprate VLAN.

What's the best way to set this up?

I can create the wireless network with no problems

SSID* = guest

Client Traffic = Bridge to VLAN

Bridge to VLAN id* =  2

But when I try to add that 'guest' network and AP to the existing Default Access Point Group, with VLAN Tagging enabled and AP VLAN ID of 2, I get an error.

Btw, both networks are allowed in the single wifi Zone.

Many thanks for any help



This thread was automatically locked due to age.
Parents
  • Hi Matthew and welcome to the UTM Community!

    Does VLAN 2 already exist?  Why not simply make this a separate zone?

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • Many thanks for the reply, Bob.

    Yep the VLAN already exists. 

    It is a VLAN interface (3.10) attached to a WLAN physical interface (3).

    If I create a separate wireless zone will I have to get rid of the existing VLAN?  

     

  • Can the AP 55 "see" VLAN 2?  If not, then use "Separate zone" and bridge the resulting virtual NIC, wlan#, to VLAN 2.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • Can the AP 55 "see" VLAN 2?  If not, then use "Separate zone" and bridge the resulting virtual NIC, wlan#, to VLAN 2.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children