This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[9.705-7] 5 Ghz Mesh no longer possible or a bug?

Hello,

Now - on UTM 9.705-7 - I wanted to set up a Mesh Network on 5 Ghz between 2 AP55 Access Points (as I did in the past). Unfortunately I cannot create the Mesh Network because of an error message (for both Root Access Point and Mesh Access Point): The AP 'xxx' is configured to operate on band '2.4 GHz' and use Mesh on conflicting band '5 GHz'.

Bests regards

This thread was automatically locked due to age.

0 LuCar Toni over 3 years ago

Mesh uses one of two available radios. AP55 has radio0 with 2,4 GHz and radio1 with 5,0 Ghz. So you can pick, which you want to use for Mesh and which you want to broadcast the network.

__________________________________________________________________________________________________________________
Cancel
Vote Up 0 Vote Down

Cancel
0 Didier Delessert over 3 years ago in reply to LuCar Toni

I understand your explanation well, but I cannot choose the radio.
I can perform a mesh in 2.4G
On the other hand I cannot do it in 5G
my 2 bands are active, because I have PCs that connect to 2.4 or 5
Cancel
Vote Up 0 Vote Down

Cancel