This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installing SUM on VM

Hello

I am currently trying to install a SUM (newly downloaded, new version) in a kvm environment.
But already at the start, I run into troubles.

The installation cant detect my storage and I cant see anyway to provide at driver.

I have tried to install UTM9. It worked right out of the box, with no special requirements.

Anyone have some experience in this?

This thread was automatically locked due to age.

0 rfcat_vk over 7 years ago

I haven't checked, but believe there is a KVM version of the ISO?

When I built my SUM on the VM I used the standard ISO.

Amended incorrect information. Changed UTM to SUM.

Both are correct.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Karsten over 7 years ago in reply to rfcat_vk

The VM version of the SUM-image are discontinued.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 7 years ago in reply to Karsten

The VM ISOs were all discontinued - just use the regular ISO. Can you see where the installation is hanging - on which driver?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 Karsten over 7 years ago in reply to BAlfson

Detecting storage devices
Detecting storage devices
Storage controller: Qumranet Qemu virtual machine
Driver: ata_pixx,ata_generic,pata_acpi
Storage controller: Qumranet SCSI storage controller
Drivers: virtio_pci
Detecting disks
Kernel: [662.648351] BIOS EDD facility v0.16 2004-jun-25, 1 devices found
No disk found, retrying after some time (2)
No disk found, retrying after some time (1)
No disk found, retrying after some time (0)
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 7 years ago in reply to Karsten

How is the scsi controller setup, if a raid array the install will not see the disks?

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 7 years ago in reply to Karsten

If you're using the same underlying Linux definition as you have with the UTM VM, this is beyond my knowledge of KVM.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 Karsten over 7 years ago in reply to BAlfson

I can mount the UTM iso at the exact same VM and install it with out any extra effort.
Cancel
Vote Up 0 Vote Down

Cancel
0 Karsten over 7 years ago in reply to rfcat_vk

rfcat_vk said:

How is the scsi controller setup, if a raid array the install will not see the disks?

No raid setup
Cancel
Vote Up 0 Vote Down

Cancel