This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Traffic Shape on RED

The RED is set to Standard/Split

I have VoIP phones connected to the RED device and they connect to a PBX on the internet. How can I apply shaping to these phones WITHOUT running all traffic through the UTM first?

This thread was automatically locked due to age.

0 BAlfson over 9 years ago

I don't believe that this is possible even with a RED 50.

You might consider replacing the RED with an SG105 with a Network Security subscription. You could either configure a RED tunnel between the two UTMs or go with a classic IPsec site-to-site.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 ManuelKarl over 9 years ago in reply to BAlfson

Hello,

the pbx is NOT on your main/hq, but in the internet, is this correct? Is your regular www-/internettraffic routed via the local router in your branch office or via utm/sg in the hq?
Cancel
Vote Up 0 Vote Down

Cancel
0 awesomo over 9 years ago in reply to ManuelKarl

Hello,

the pbx is NOT on your main/hq, but in the internet, is this correct? Is your regular www-/internettraffic routed via the local router in your branch office or via utm/sg in the hq?

Yes, it is out on the internet. Yes, internet traffic is routed via the RED in the branch office.
Cancel
Vote Up 0 Vote Down

Cancel
0 Scott_Klassen over 9 years ago

Without routing the traffic through a UTM, you won't be able to apply QoS/shape the traffic, as the RED itself doesn't have that capability. A RED is just a VPN Client and routing table.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 ManuelKarl over 9 years ago in reply to Scott_Klassen

When the VoIP-Traffic leaves your branch office via regular router/gateway (NOT thru the sophos/red tunnel), then you have to set QoS on your default gateway (e.g. CISCO or s.t.).
Cancel
Vote Up 0 Vote Down

Cancel