This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Traffic Shape on RED

The RED is set to Standard/Split

I have VoIP phones connected to the RED device and they connect to a PBX on the internet. How can I apply shaping to these phones WITHOUT running all traffic through the UTM first?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

Without routing the traffic through a UTM, you won't be able to apply QoS/shape the traffic, as the RED itself doesn't have that capability. A RED is just a VPN Client and routing table.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 ManuelKarl over 9 years ago in reply to Scott_Klassen

When the VoIP-Traffic leaves your branch office via regular router/gateway (NOT thru the sophos/red tunnel), then you have to set QoS on your default gateway (e.g. CISCO or s.t.).
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 ManuelKarl over 9 years ago in reply to Scott_Klassen

When the VoIP-Traffic leaves your branch office via regular router/gateway (NOT thru the sophos/red tunnel), then you have to set QoS on your default gateway (e.g. CISCO or s.t.).
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data