Whenever i plug my sophos utm9 into a switch the wan port link is up but its state goes down?

Hi Robert , 

Could you provide us additional information for the same scenario you are implementing with UTM9

1. Version  VM/Device

2. WAN network , Lan Network address

3. Physical Topology of the network.

4. Bridge/Gateway mode.

Thanks and regards

Aditya Patel | Network and security engineer.

sure thing Version is 9.407-3 patter version is 110611

the sophos lan is on 192.168.2.100 the wan is dynamic 

the linksys srw2008p switch is set to static ip 192.168.0.1

and the ubiquiti access point is set to 192.168.1.2 

I have the motorola surfboard sb6190 connected to the srw2008p switch then the switch connected to the sophos utm and then the wan out connected to the unifi access point.

I want to be able to add a second network that bypasses the sophos utm

im not sure if the switch has a bridge mode.

Thank you in advance

Wouldn't it be easier to plug the External interface directly into the modem and bridge an unused NIC with External?

Cheers - Bob

So plug the modem into the Sophia LAN and configure another lan to connect to the switch? Do I need to use Ethernet bridge mode?

Hi,

you appear to be trying to make life difficult for yourself?

why are you putting the UTM on the inside of a protected network?

Why not put the modem into bridge mode and have the UTM provide the internet connection. On the UTM setup a second port with all traffic allowed out so your wifi device can access the internet?

What you are trying to do will require your modem to have two networks and vlans. Does the modem provide to IP address ranges on its internal interface, from your description it doesn't and you are trying to use the switch to do that.

The modem only has one lan port it's a Motorola surfboard not sure if it has that possibility my network map goes the ISP to the modem through coax I'm trying to set up 2 networks one that uses the Sophia utm and the other without so I don't have to filter multiple things

Good insight, Ian - I didn't read closely enough!  I doubt his ISP would let him lease two public IPs or that his switch is also a router.

Ian's right, Robert.  Put your modem into bridge mode and configure the External interface to be dynamic Ethernet with a default gateway.  Now you will have a public IP on the External interface.

Leave the rest of your configuration as is, but make some additions:

1. Configure another Interface named "Wireless" for the separate network and attach the AP directly to that NIC.
2. Make a Masquerading rule 'Wireless (Network) -> External'.
3. Make a firewall rule ''Wireless (Network) -> Any -> Internet : Allow'.

An alternative would be to attach the switch to the NIC and the AP and other devices to the switch, but your description made it sound like the AP was the only wired device on that subnet.

Cheers - Bob

Hi Bob,

 I know those uq thing require internet access so you can manage them, plain stupidity having to open your network so you can manage the internal device by an external website.

I know uq want you to buy their firewall stuff, but even then you still need a licence for the AP and it still needs to call to uq hq to be managed. Very poor network security devices, all your internal traffic also managed by an external site not under your control.

Hi Bob,

 I know those uq thing require internet access so you can manage them, plain stupidity having to open your network so you can manage the internal device by an external website.

I know uq want you to buy their firewall stuff, but even then you still need a licence for the AP and it still needs to call to uq hq to be managed. Very poor network security devices, all your internal traffic also managed by an external site not under your control.