This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HOW TO ENABLE BGP IN SOPHOS

Default enable or else need to enable?



This thread was automatically locked due to age.
Parents
  • BGP neighbor is 10.173.1.33, remote AS 65005, local AS 65003, external link
      BGP version 4, remote router ID 0.0.0.0
      BGP state = Active
      Last read 03:22:46, hold time is 180, keepalive interval is 60 seconds
      Message statistics:
        Inq depth is 0
        Outq depth is 0
                             Sent       Rcvd
        Opens:                  0          0
        Notifications:          0          0
        Updates:                0          0
        Keepalives:             0          0
        Route Refresh:          0          0
        Capability:             0          0
        Total:                  0          0
      Minimum time between advertisement runs is 30 seconds
    
     For address family: IPv4 Unicast
      Community attribute sent to this neighbor(both)
      0 accepted prefixes
    
      Connections established 0; dropped 0
      Last reset never
    Next connect timer due in 25 seconds
    Read thread: off  Write thread: off
    
  • Vaṇakkã Ramani and welcome to the UTM Community!

    Please show pictures of the Edits of the BGP configurations with 'Advanced' open where applicable.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • Vaṇakkã Ramani and welcome to the UTM Community!

    Please show pictures of the Edits of the BGP configurations with 'Advanced' open where applicable.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data