HOW TO ENABLE BGP IN SOPHOS

Hi Ramani Ramalingam,

Thanks for reaching out to the Community! 

You can turn on BGP and configure it from Interface & Routing > Border Gateway Protocol. 

Thanks,

BGP neighbor is 10.173.1.33, remote AS 65005, local AS 65003, external link
  BGP version 4, remote router ID 0.0.0.0
  BGP state = Active
  Last read 03:22:46, hold time is 180, keepalive interval is 60 seconds
  Message statistics:
    Inq depth is 0
    Outq depth is 0
                         Sent       Rcvd
    Opens:                  0          0
    Notifications:          0          0
    Updates:                0          0
    Keepalives:             0          0
    Route Refresh:          0          0
    Capability:             0          0
    Total:                  0          0
  Minimum time between advertisement runs is 30 seconds

 For address family: IPv4 Unicast
  Community attribute sent to this neighbor(both)
  0 accepted prefixes

  Connections established 0; dropped 0
  Last reset never
Next connect timer due in 25 seconds
Read thread: off  Write thread: off

Already config done but bgp not establish

Vaṇakkã Ramani and welcome to the UTM Community!

Please show pictures of the Edits of the BGP configurations with 'Advanced' open where applicable.

Cheers - Bob