Default enable or else need to enable?
This thread was automatically locked due to age.
Default enable or else need to enable?
BGP neighbor is 10.173.1.33, remote AS 65005, local AS 65003, external link BGP version 4, remote router ID 0.0.0.0 BGP state = Active Last read 03:22:46, hold time is 180, keepalive interval is 60 seconds Message statistics: Inq depth is 0 Outq depth is 0 Sent Rcvd Opens: 0 0 Notifications: 0 0 Updates: 0 0 Keepalives: 0 0 Route Refresh: 0 0 Capability: 0 0 Total: 0 0 Minimum time between advertisement runs is 30 seconds For address family: IPv4 Unicast Community attribute sent to this neighbor(both) 0 accepted prefixes Connections established 0; dropped 0 Last reset never Next connect timer due in 25 seconds Read thread: off Write thread: off
BGP neighbor is 10.173.1.33, remote AS 65005, local AS 65003, external link BGP version 4, remote router ID 0.0.0.0 BGP state = Active Last read 03:22:46, hold time is 180, keepalive interval is 60 seconds Message statistics: Inq depth is 0 Outq depth is 0 Sent Rcvd Opens: 0 0 Notifications: 0 0 Updates: 0 0 Keepalives: 0 0 Route Refresh: 0 0 Capability: 0 0 Total: 0 0 Minimum time between advertisement runs is 30 seconds For address family: IPv4 Unicast Community attribute sent to this neighbor(both) 0 accepted prefixes Connections established 0; dropped 0 Last reset never Next connect timer due in 25 seconds Read thread: off Write thread: off
Vaṇakkã Ramani and welcome to the UTM Community!
Please show pictures of the Edits of the BGP configurations with 'Advanced' open where applicable.
Cheers - Bob