Thread Info
  • State Suggested Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 6 subscribers
  • Views 8345 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Upgrade UTM 220 to SG230

Paul Mark Valenzuela

Hi.

 

I got 2x UTM 220 configured in HA cluster.

We plan to get 2x SG230 and replace our existing 2x UTM 220.

 

I know we can restore our backups to the newer SG230, I have done this on stand-alone models and it works well.

 

Questions:

 

Question 1: Cut-Over

However, how should I start with 2x SG230? The devices are located off-site.

Should I configure 2x SG230 on an HA cluster before restoring the UTM 220 backup on the master node ?

or do I just restore the backup on 1x SG230 and connect the 2nd SG230 and system will automatically detect the second node fresh from the box (no configuration) ?

 

 

Question 2:

If I remove the secondary node (UTM220) and replace it with an SG230 will the HA Cluster automatically configure it a the new secondary node ? 

Do I need to do anything on the SG230 before connecting it to the UTM 220 master node?

How about the licenses?

 

 

 

Thanks,

Paul

 

 



This thread was automatically locked due to age.
Parents
  • 0

    Hallo Paul,

    I think it is not possible to do the change without an interruption.

    I would proceed as follows:

    In your office the restore the backup of the sg220 in one sg230 (master)

    Check whether everything is plausible. Then connect the second sg230.

    Which should then bring itself to the position of the master sg 230.

    If not find the error.

    If yes, then test: swivel boot etc. then rollout to the distant location.

    Now let the sg220 going out of service and then the sg230 put into operation and after successful check bring the second unit in operation.

    Then check again the function.

    In the worth case you have the old sg220 in reserve.

    In my opinion the licence is fixed to the device by  the serial number.

    It seems no problem with the backups and the new sg230, i think.  But you will know it after the first step.

    Regards Ster

                                         

    "mal eben"    gibt es nicht

  • 0 in reply to Ster Linga

    Thanks for this.

     

    After I restore the backup on one SG230 (master).

    When I connect the 2nd SG230 (slave) will the master auto detect and join the slave to the cluster automatically? Do I need to do anything on the slave?

     

     

     

  • +1 in reply to Paul Mark Valenzuela

    Hi Paul,

    You just need all the configurations completed on the MASTER, SLAVE will synchronize the needed information from MASTER.

    Thanks

    Sachin Gurung
    Team Lead | Sophos Technical Support
    Knowledge Base  |  @SophosSupport  |  Video tutorials
    Remember to like a post.  If a post (on a question thread) solves your question use the 'This helped me' link.

Reply Children
No Data
Unfiltered HTML