This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Wipe ASG220 and reinstall again. Can't get access the web admin after install completed.?

Anyone know ways to get it works.

I wipe my ASG220 and reinstall again. After it completed installation. It says you can access the https://192.168.2.254:4444 . I connect the Eth0 to the Laptop and setup the static ip: 192.168.2.5, and gateway is 192.168.2.254. then I input the https://192.168.2.254:4444 to the internet explore browser. I never get to the web admin at all. It can not connect. I need help. Your help is very appreciated.

This thread was automatically locked due to age.

0 sachingurung over 8 years ago

Hi,

Which firmware version did you installed on the UTM? If you reimaged it, you need to connect it on the default IP address i.e., 192.168.0.1 (255.255.255.0).

Please try to get the Web Admin access on https://192.168.0.1:4444.

Thanks

Sachin Gurung
Team Lead | Sophos Technical Support
Knowledge Base | @SophosSupport | Video tutorials
Remember to like a post. If a post (on a question thread) solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel
0 GerVang over 8 years ago

I think I did a mistake. I never get it to installed. I thought I did it. However, I will try to get it install tonight and see if I can add the home license.

Thank you
Cancel
Vote Up 0 Vote Down

Cancel