This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Intel I354 NICs only running in 100Mbit Mode

Error: Ports eth0-eth3 on a SG135 rev2 will currently only run at 100Mbit. This error persists whether you run a hardware version, or even if you were to rip out the SSD, install another one and run the SG135 on a software license for the lols. The error persist no matter which switch or NIC you throw at it at the other end.

Affected Model: SG135 Rev2

Model has 8 Interfaces.

eth0-eth3 = Intel Corporation Ethernet Connection I354

eth4-eth7 = Intel Corporation I211 Gigabit Network Connection

According to Intel, the I350 Chipset is Gigabit capable. The i354 in the Sophos indicates that it is the quad port variant of the i350 chip.

Source: https://www.intel.com/content/www/us/en/products/details/ethernet/gigabit-controllers/i350-controllers/downloads.html

Question: Is there a way to get the SG135 back to speed, or is this one of these legacy hardware bugs nobody gives two flying expletives about?



This thread was automatically locked due to age.
Parents Reply
  • What does the Hardware Interfaces tab look like on your UTM as well?  Can you take a screenshot of that?

    Interfaces & Routing > Interfaces > Hardware tab

    Have you tried to force 1000MB on the hardware?  

    OPNSense 64-bit | Intel Xeon 4-core v3 1225 3.20Ghz
    16GB Memory | 500GB SSD HDD | ATT Fiber 1GB
    (Former Sophos UTM Veteran, Former XG Rookie)

Children
No Data