Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 7 subscribers
  • Views 1152 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No Access to UTM

RemoHehlert

Hello,

we have no access to our UTM via SSH or https

on Borwser i get PR_END_OF_FILE_ERROR

on putty i get Network error: Connection refuse

Both are working before.

How can i get access?

wrbrgds

R.



This thread was automatically locked due to age.
Parents
  • 0

    Hi 

    looks like you screwed up something with your certs.

    Have you tried to connect to WebAdmin with Edge/Chrome?

    Also try to temp. bypass any local AV/WebProtection software which might prevent you from accessing non-secure hosts.

    regards

  • 0 in reply to oly s

    The problem is that the active FW no longer recognizes its hard disk.
    However, it is surprising why the standy system does not start automatically but only after the master has been switched off.

  • 0 in reply to RemoHehlert

    Sorry to read – bad luck

    Unfortunately, I cannot assist. Have two units here, meant for running in a cluster. Predecessors and their consultants never got it to run and when I had it finally on my agenda and started, I had to send the unit offsite to bring that site back online. The time they returned it, I had other priorities – so no practice/experience regarding UTM clustering.

Reply
  • 0 in reply to RemoHehlert

    Sorry to read – bad luck

    Unfortunately, I cannot assist. Have two units here, meant for running in a cluster. Predecessors and their consultants never got it to run and when I had it finally on my agenda and started, I had to send the unit offsite to bring that site back online. The time they returned it, I had other priorities – so no practice/experience regarding UTM clustering.

Children
No Data
Unfiltered HTML