No Access to UTM

Hi 

looks like you screwed up something with your certs.

Have you tried to connect to WebAdmin with Edge/Chrome?

Also try to temp. bypass any local AV/WebProtection software which might prevent you from accessing non-secure hosts.

regards

The problem is that the active FW no longer recognizes its hard disk.
However, it is surprising why the standy system does not start automatically but only after the master has been switched off.

The problem is that the active FW no longer recognizes its hard disk.
However, it is surprising why the standy system does not start automatically but only after the master has been switched off.

Sorry to read – bad luck

Unfortunately, I cannot assist. Have two units here, meant for running in a cluster. Predecessors and their consultants never got it to run and when I had it finally on my agenda and started, I had to send the unit offsite to bring that site back online. The time they returned it, I had other priorities – so no practice/experience regarding UTM clustering.