This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Full System Scan indicator

Hi guys,

New to the forum and have a question regarding system console 4.0 and full system scanning.

Right-clicking on a workstation and selecting "Full System Scan..." you need to click OK on the pop-up to proceed. My issue is that once you click on OK there is no indictor on the console that a scan is running on that workstation. Is there a way to enable this or is this a limitation with the product?

R/Alex

This thread was automatically locked due to age.

Parents

0 mdp23005 over 14 years ago

I'm late to this topic but support the proposals mentioned above. It is not user-friiendly to inititate a full scan then have to make a note to myself to check that PC hours later to see its status.
:2643
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 mdp23005 over 14 years ago

I'm late to this topic but support the proposals mentioned above. It is not user-friiendly to inititate a full scan then have to make a note to myself to check that PC hours later to see its status.
:2643
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data