This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

wlan2 connect to vlan92

Hi,

i got 1 more question.

i got wlan2 working the AP55 is connected to my INTERNAL network
wlan2 is using Multipath to my WAN2

WLAN0(Bridge APLAN)--> via Internal-->UTM-->Wan1
____WLAN2(sep zone)-->via Internal-->UTM-->WAN2
___________________Lan2<>

This thread was automatically locked due to age.

0 BAlfson over 9 years ago

WebAdmin creates routes between all subnets defined on one of its interfaces, so all you need is firewall rules to allow traffic between two of them. If you need a masq rule, it's an indication that you have some definitions that violate #3 in Rulz.

Defining VLAN92 on wlan2 is not necessary if your internal devices don't support that.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel