Hi -
Looking for some advice on how to debug a performance problem.
I have an AP10 and an AP30. Performance on both is terrible. With a perf testing site, I am getting 1.8Mbps down and 3.8Mbps up. When I plug in with a wire, I am getting 30.8Mbps down and 4.2Mbps up. I have tried unplugging the AP30 and using that same wire into the computer and I still get the better performance.
It used to work much better, not sure when things went bad.
I used netstumbler and don't see interference on the networks.
I unplugged cordless phone.
I have tried changing from channel 11 to 1.
The only think slightly strange in the wireless log is that I am seeing RADIUS messages when I do not have radius enabled. Had looked into it, but didn't think I ever turned it on.
2014:02:16-17:51:42 192.168.1.100 hostapd: wlan1: STA a4:5d:36:56:54:9e IEEE 802.1X: authorizing port
2014:02:16-17:51:42 192.168.1.100 hostapd: wlan1: STA a4:5d:36:56:54:9e RADIUS: starting accounting session 5300D524-00000016
Where should I start? Running 9.108-23.
Practically everything disabled -
Status: Enabled Firewall is active with 49 rules
Status: Disabled Intrusion Prevention is inactive
Status: Disabled Web Filtering is inactive
Status: Disabled Network Visibility is inactive
Status: Disabled SMTP Proxy is inactive
Status: Disabled POP3 Proxy is inactive
Status: Disabled RED is inactive
Status: Enabled Wireless Protection is active, 1 APs connected
Status: Disabled Endpoint Protection is inactive
Status: Enabled Site-to-Site VPN is active with 3 of 3 tunnels
Status: Enabled Remote Access is active with 0 online users
Status: Disabled Web Application Firewall is inactive
Status: Disabled HA/Cluster is inactive
Status: Disabled Sophos UTM Manager is not configured
Status: Disabled Antivirus is inactive
Status: Disabled Antispam is inactive
Status: Disabled Antispyware is inactive
This thread was automatically locked due to age.
