This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

wrong wireless status and some more problems

Hello,

we recognize some problems with wireless protection. We have 4xAP10 and 1xAP30 Access Points ...

In the wireless status I see some devices from colleagues connected more than 16 hours to the AP30 ... that´s wrong, because my colleagues don´t work so long. Why does the wireless protection does not updates the correct status?

And another problem: I sit next to the AP30, I would say 2 meters away but my iPhone connects to a AP10 which is approximately 20m away. Why?

Only after power cycling the AP30 shows the correct connected devices and I can connect again to the AP.

What can cause that troubles?

Cheers, Tom

This thread was automatically locked due to age.

Parents

0 tomtomtom over 11 years ago

Hi,

we are using UTM Release 9.102-8 in a virtual appliance.

My workmates mostly using mobile phones, like iPhone or Android phones. They don´t go into standby.

The other problem: why does my iPhone connects correct, if I reboot the AP30? It does not make any sense. Switching of WiFi on iPhone is not enough. I need to power cycle the AP. It seems that the UTM is balancing sometimes the connections to the APs. The AP30 is more frequented than the AP10 - is that the reason?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 tomtomtom over 11 years ago

Hi,

we are using UTM Release 9.102-8 in a virtual appliance.

My workmates mostly using mobile phones, like iPhone or Android phones. They don´t go into standby.

The other problem: why does my iPhone connects correct, if I reboot the AP30? It does not make any sense. Switching of WiFi on iPhone is not enough. I need to power cycle the AP. It seems that the UTM is balancing sometimes the connections to the APs. The AP30 is more frequented than the AP10 - is that the reason?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data