This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP 50 lost 5Ghz function....

Hello,

I have a relay strange behavior of my AP50.

I was able to connect the AP and configure the SSID´s also one with 5Ghz.

I could connect with my PC to the WLAN and the world was fine....BUT then was a Firmware-update made by the ASG and now i get following error in logfile why the AP is started:


sysinit: PHY for wifi device radio1 not found

and the 5Ghz is not working anymore....

I have no idea [:(]

Regards Frank from Germany (so sorry for the strange English)

This thread was automatically locked due to age.

Parents

0 BarryG over 11 years ago

Hi, it's possible the 5GHz radio isn't working, perhaps due to a hardware or firmware problem.

Do you have a support contract?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 dapor over 11 years ago in reply to BarryG

I do not have a support contract.

I aso think that es is a hardware failure, because when I start the AP after a while leaving powerless the 5Ghz module is working for about 10 -15 min...and than it is gone again....
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 dapor over 11 years ago in reply to BarryG

I do not have a support contract.

I aso think that es is a hardware failure, because when I start the AP after a while leaving powerless the 5Ghz module is working for about 10 -15 min...and than it is gone again....
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data