This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WIFI separated

Hello,

I would like to ask you if it is possible to have 2 WIFI Networks separated. I mean, for the first network I want that all traffic is sent by the tunnel to UTM. For the second I want a WIFI guest just for internet and use the remote internet line, not UTM Tunnel.

Is that possible?

Thanks

This thread was automatically locked due to age.

Parents

0 BAlfson over 11 years ago

Guys, the only way I guess this might work for zero7 would be for the AP 30 to be "bridged to the AP lan" with 'Client isolation: Disabled' and setup the RED as Split. Even then, I'm not certain that "UTM APs connect to the UTM via a tunnel" doesn't override that and that the AP traffic doesn't have to go through the AP tunnel first. I think it should work, though!

Zero7, please let us know if this works with and without 'Client isolation: Disabled'...

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 11 years ago

Guys, the only way I guess this might work for zero7 would be for the AP 30 to be "bridged to the AP lan" with 'Client isolation: Disabled' and setup the RED as Split. Even then, I'm not certain that "UTM APs connect to the UTM via a tunnel" doesn't override that and that the AP traffic doesn't have to go through the AP tunnel first. I think it should work, though!

Zero7, please let us know if this works with and without 'Client isolation: Disabled'...

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 zero7 over 11 years ago in reply to BAlfson

I selected separate zone for my guest wifi but it doesn't work. I didn't receive an IP from dhcp althought I configured it.

Just to be clear, I don't want to use the tunnel and access to my networks on utm side. I just want to be able to use internet with remote internet line for guests.
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 11 years ago in reply to zero7

You will have to create a new DHCP server for the local interface to be able to allocate IP addresses to guests.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 zero7 over 11 years ago in reply to rfcat_vk

So I have to create a dhcp server on my guest network?

Because in the utm admin guide, for separated zone I have to create a new network interface, new dhcp, dns, nat & masq rules.
Cancel
Vote Up 0 Vote Down

Cancel
0 zero7 over 11 years ago in reply to zero7

DHCP is working, I had a config problem but internet doesn't work...

Any idea?
Cancel
Vote Up 0 Vote Down

Cancel