This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Publish Sophos UTM portal

Hey everyone,

I'm new with Sophos product, I try to pratice in a lab.

I'm trying to use the Sophos UTM user portal to allow my users to connect to servers remotely.

I activated the user portal, in internal network the portal is ok. But I don't arrive to publish the portal through internet.

Can someone has an idea ?

my configuration :
Eth0: External
Eth1: Internal

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

The assumption here is that you have one or more other routers between the internet and the UTM (lab). If this is the case, you'll need to forward the traffic to the UTM.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 Guillaume V over 9 years ago in reply to Scott_Klassen

Thank you very much.

I looked in my Internet router, in addition to set the server in the DMZ, I have to set Port Forwarding.

This is why I had a problem. My previous router did not required it.

Thank you for your help.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Guillaume V over 9 years ago in reply to Scott_Klassen

Thank you very much.

I looked in my Internet router, in addition to set the server in the DMZ, I have to set Port Forwarding.

This is why I had a problem. My previous router did not required it.

Thank you for your help.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Mohannad over 9 years ago in reply to Guillaume V

Open the RemoteAccess>SSL>Settings tab

change interface address , remove any and add an interface with the public IP address , click apply , you'll be worned about changing the portal address ...chose ok .

Hope this help
Cancel
Vote Up 0 Vote Down

Cancel