This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Configure ACC on VMWare - Home Environment-

So I was able to get VMWare installed on my Mac Mini in my home environment, the problem is I can't see to get any external connectivity.

My question is how are the Network Adaptors supposed to be setup on the Mini?

My home environment is setup like this:

External Static IP coming into my house. I have forwarded ports 4433, 4443 (I changed from 4422), and 4444 to the physical device running the VMWare session.  So whenever any traffic comes to my static IP on any of those ports it is routed to my Mac Mini running VMWare ACC 8.003.

I have also created a DNS entry on my domain called accvm.domain.com that points to my static IP address.

I have tested this setup with an Amazon EC2 image and it works fine, so there is something I am missing with the VMWare NICs.  Should they be NAT or Bridge, etc.  If someone could give me a general lesson on how to configure I'd appreciate it.

Thanks

This thread was automatically locked due to age.

Parents

0 BAlfson over 12 years ago

I know very little about VMware, but I have the V9 beta in a VM set up with the Internal interface on a NIC with "NAT" and the External on one that's "Bridged."

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 12 years ago

I know very little about VMware, but I have the V9 beta in a VM set up with the Internal interface on a NIC with "NAT" and the External on one that's "Bridged."

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data