This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reset Red50 / Connect to other UTM [Solved]

Hi,

I purchased a used Red50 on eBay. The configuration in the UTM worked fine, as the seller hav provided the Code. Now I wanted to connect the RED50 via internet, but it does not connect. On the display it shows the old UTM address and does not go on. I also waited some 10 minutes but it always shuts down and restarts.

Any clue how to reset the RED50 or conntect to the new UTM?

Thanks

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

In my RED devices I don't see the download button Scott has mentioned though
Only available with Red50s I believe and you have to choose to deploy via USB under advanced when first creating the configuration. The more I read into it, the more of a PITA it seems to use though.

Edit: Issue solved for Achim

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 mjpmotw over 9 years ago in reply to Scott_Klassen

I have a RED 10 connected to my UTM320.

Now I want to remove it from this UTM320 and use i with another location with a UTM230.

I don't have an unlock code as my colleage already deleted the interface on my UTM320.

How can I recover my RED 10?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 mjpmotw over 9 years ago in reply to Scott_Klassen

I have a RED 10 connected to my UTM320.

Now I want to remove it from this UTM320 and use i with another location with a UTM230.

I don't have an unlock code as my colleage already deleted the interface on my UTM320.

How can I recover my RED 10?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data