This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED50 With Static IP

We have a RED50 we're trying to install and the ISP has a modem that provides either static, public addresses or dhcp, private addresses. How can we configure the RED50 with a static IP address for the ISP gateway?

This thread was automatically locked due to age.

0 Scott_Klassen over 10 years ago

https://www.sophos.com/en-us/support/knowledgebase/116573.aspx Read that document.. The major point for your scenario being that after configuration of the RED on your UTM, you MUST connect the RED via DHCP once, so that it can pull the config you created from the provisioning server, then it will have the static IP you gave it.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 maygyver over 10 years ago

I would use private dhcp IP.

Astaro user since 2001 - Astaro/Sophos Partner since 2008
Cancel
Vote Up 0 Vote Down

Cancel