This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't access device behind RED

Hi I have a site setup with the following setup

Internal>ASG120Cluster->WAN->Router serving DHCP>RED10>Cisco>Client PC's

My RED is in standard unified mode and has an interface 172.16.250.1/29 serving DHCP on 172.16.250.4-6
The RED is 172.16.250.1 the Cisco WAN side is 172.16.250.2 

The Cisco can ping external addresses on my ASG Cluster as can client PC's

however I can't ping the Cisco or client pc's from the ASG or anything inside it.  I can ping my RED address however.

Firewall rules are Trusted networks(internal etc)>any>any and RED network and client networks>ports they require(https etc)>external address of virtual webserver (server load balancing)

Any ideas?


This thread was automatically locked due to age.
Parents
  • Firebear, if the IP is not on the interface but is on another device in the subnet of the interface, binding the object to the interface will cause routing problems for VPNs and DNATs.  There are some uses for binding to an interface, but doing so will cause most admins to have mysterious problems.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • Firebear, if the IP is not on the interface but is on another device in the subnet of the interface, binding the object to the interface will cause routing problems for VPNs and DNATs.  There are some uses for binding to an interface, but doing so will cause most admins to have mysterious problems.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children