Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 2 subscribers
  • Views 6437 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Transparent/Split Tunneling in RED.

red_diablo2004
Hi all,

Hope you are doing well.

I have ASG 220 with v. 8.100 and I tried transparent/split and it didn't work but standard worked well.

Are there any requirements other than what the deployment helper have?

And thanks in advance.


This thread was automatically locked due to age.
Parents
  • 0
    Maybe tell us what you want to achive? [[:)]]

    RED in transparent/split mode is good if

    - You don't want to change the remote network numbering or layout
    - You don't want to apply security functions to the remote network's internet traffic
    - You only want to establish two-way site-to-site connectivity in an uncomplicated manner. [[:)]]

    The default use case which is configured by the deployment helper will add a DHCP client (aka "Cable modem") interface on the ASG on the redsX interface. That means the ASG will pull an IP from the remote network.

    /tom
  • 0 in reply to tom_01
    Hi Tom,

    Yes, that what I want to do but I don't know where should I position RED device properly?

    And which network should I put in Network Split? The Remote one or The Local one?

    Because I think the Transparent/Split mode is similar to Stanard/Split mode, am I right? 
     
    And thanks in advance.
  • 0 in reply to red_diablo2004
    I have a client 11 branches and he needs Transparent/Split mode, and no one told how to do it?

    Shall I go with Unified mode?

    And thanks in advance.
Reply Children
Unfiltered HTML