This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

unable to set initial keys

Hi all,

I got an Problem with my new red device. I've set it up in our ASG220. (no split tunnel) At Home, i've connected it with my fritz.box. Everything works fine but the tunnel dont come up. In live log on ASG, I can see only one thing:

unable to set initial keys

I've tried to set it up in many different ways but I have no Idea why the tunnel don't came up.

Has anyone an Idea how to get it work. I don't know what I do wrong.

This thread was automatically locked due to age.

0 tom_01 over 14 years ago

What ASG version (V7 or V8) do you have?

Also, what does "cat /proc/net/red" on the commandline say?
Cancel
Vote Up 0 Vote Down

Cancel
0 3lp4dr1n0 over 14 years ago in reply to tom_01

I have V8,

/proc/net/red says:

id 0800, peer redw0 172.16.1.104, keyid 0, RX seq 0, TX seq 0, crypto 0, refcnt 1
Cancel
Vote Up 0 Vote Down

Cancel
0 tom_01 over 14 years ago

Sorry for the delay.

This is a bug in both V7 and V8. It happens when you use both WiFi and RED, then delete the last RED device.

To work around the bug, reboot the machine. While at least one RED config is present, the bug should not occur again.
Cancel
Vote Up 0 Vote Down

Cancel
0 3lp4dr1n0 over 14 years ago in reply to tom_01

Hi Tom,

no Prob. Thanks a lot. Now, the I can enjoy my RED device ;-)

Best regards
Cancel
Vote Up 0 Vote Down

Cancel