This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Red security control

So i setup a red to use split tunnel and its working great.

I can see everything on my office network and my office network can see everything on my network.

i want to continue to see everything on my office network. How do i limit it so that no one in my office can scan my network. i want only RDP , file transfer and icmp ping to work back to my home network.

by the way i have an ASG home edition at home.

This thread was automatically locked due to age.

Parents

0 BarryG over 14 years ago

Hi,
Is the RED inside or outside your home firewall?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 vannyx over 14 years ago in reply to BarryG

So for split tunnel
The wan port connects to my network and gets a DHCP address
the lan port is connected to my network and i assign a IP for my network on the work ASG.

my home ASG forwards requests for my work subnet to the lan port and then the response comes back over the tunnel on the wan port.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 vannyx over 14 years ago in reply to BarryG

So for split tunnel
The wan port connects to my network and gets a DHCP address
the lan port is connected to my network and i assign a IP for my network on the work ASG.

my home ASG forwards requests for my work subnet to the lan port and then the response comes back over the tunnel on the wan port.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data