This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Replace RED (how to take over the config)

Hi,
what happens with the config, if a RED gets defekt and have to replace. For fault tolerance we whant to have a secound RED as cold standby.
Following questions did i have:

- Can I configure a secound RED with the same SubNet?
- Can I replace the RED ID and unlook Code in an existing configuration?

What is the best way.

thanks for help
yours
Björn

This thread was automatically locked due to age.

Parents

0 trollvottel over 14 years ago

You can also do cold-standby by joining the two REDs into the same physical network by bridging them at the ASG. Then you can turn one of them off/on at any time.
Cancel
Vote Up 0 Vote Down

Cancel
0 Sascha Paris over 14 years ago in reply to trollvottel

You also can use same subnet across some RED devices by simply bridging them.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Sascha Paris over 14 years ago in reply to trollvottel

You also can use same subnet across some RED devices by simply bridging them.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data