This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM-to-UTM RED connection and Hotspot Problems

Hello,

I have small problems with my UTM-to-UTM RED connection and the Hotspot. After found the solution with the magic ip, I'am able to manage the APs. The APs even get my Hotspot-Wifi and clients can connect. But they did not get an address,

Is there any solution for this? What has to be done? We don't want to use the second utm to manage wireless infrastructure in the other location.

Thanks, Sebastian

This thread was automatically locked due to age.

Parents

0 Jaydeep over 4 years ago

Hi Sebastian Wittmann1

So you want UTM1 to manage your APs behind UTM2 via a RED tunnel to UTM 1, is that right? Also, do you the traffic for DHCP going across the RED tunnel? Have you tried configuring a DHCP relay or is it part of your configuration?

Regards

Jaydeep
Cancel
Vote Up 0 Vote Down

Cancel
0 Sebastian Wittmann1 over 4 years ago in reply to Jaydeep

Hi Jaydeep,

Yes, right, UTM2 is configured an RED-Device an UTM1 (https://community.sophos.com/kb/en-us/120157)

No DHCP-Relay is not part of my config.

Sebastian
Cancel
Vote Up 0 Vote Down

Cancel
0 Sebastian Wittmann1 over 4 years ago in reply to Sebastian Wittmann1

Problem is solved. :-)

https://community.sophos.com/products/unified-threat-management/f/wireless-security/85109/no-dhcp-offers-in-seperate-zone-wlan

Best regards.

Sebastian
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Sebastian Wittmann1 over 4 years ago in reply to Sebastian Wittmann1

Problem is solved. :-)

https://community.sophos.com/products/unified-threat-management/f/wireless-security/85109/no-dhcp-offers-in-seperate-zone-wlan

Best regards.

Sebastian
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data