This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[9.102][BUG]DNAT creates Network Definition

Hi,

i have created a DNAT Rule (like Szenario 2 : How to Port Forward Service Ports with NAT: Astaro Security Gateway)

After Rule creatation a Service Definition will be created and after each on/off of DNAT rule it will be re-created...

I use UTM 9.1 latest Patch Level.

Any hints? It's very annoying to delete wasted stuff...

This thread was automatically locked due to age.

Parents

0 InterHmai over 11 years ago

9.106-17 with a new 320 box we set up, fresh config with settings manually input.

DNAT rules would create tons of services/rules despite existing ones being selected during DNAT setup.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 InterHmai over 11 years ago

9.106-17 with a new 320 box we set up, fresh config with settings manually input.

DNAT rules would create tons of services/rules despite existing ones being selected during DNAT setup.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Mast_01 over 10 years ago in reply to InterHmai

9.106-17 with a new 320 box we set up, fresh config with settings manually input.

DNAT rules would create tons of services/rules despite existing ones being selected during DNAT setup.

yeah i'm seing thison a 9.204 box as well it was installed FRESH with 9.200, nat rules that have "automatic FW rule" generate needless service definitions
Cancel
Vote Up 0 Vote Down

Cancel