This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SG UTM on XCP-ng 7.6 Hypervisor dropping traffic

Looking for suggestions on how to find the cause of tcp communication failures.

 

I have some systems running "behind" a DomU SG UTM Firmware version: 9.714-4 on a XCP-ng 7.6 hypervisor with an AMD Opteron 6220 CPU. Everything works fine. Specifically, my backup software is being NATed through the UTM.

 

When I migrate the UTM to a XCP-ng 7.6 Hypervisor running on an AMD EPYC processor, the same TCP backup traffic drops the connection. The ONLY change is moving the UTM to the new hypervisor.



This thread was automatically locked due to age.
Parents
  • What NIC does your hardware have?  Are you seeing any up/down messages in the Kernel log?  Is it specific TCP traffic, i.e., port 80/443?  Is it a custom TCP port?  Can you paste some errors from the log files?

    OPNSense 64-bit | Intel Xeon 4-core v3 1225 3.20Ghz
    16GB Memory | 500GB SSD HDD | ATT Fiber 1GB
    (Former Sophos UTM Veteran, Former XG Rookie)

Reply
  • What NIC does your hardware have?  Are you seeing any up/down messages in the Kernel log?  Is it specific TCP traffic, i.e., port 80/443?  Is it a custom TCP port?  Can you paste some errors from the log files?

    OPNSense 64-bit | Intel Xeon 4-core v3 1225 3.20Ghz
    16GB Memory | 500GB SSD HDD | ATT Fiber 1GB
    (Former Sophos UTM Veteran, Former XG Rookie)

Children
No Data