This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[Solved] - User error - UTM not accepting a firewall rule (or... I'm an idiot) help please

So this is basic

I'm setting up a firewall rule to allow specific VPN traffic

Here's the specific service definition

Attempting to setup a VPN, I get this...

Here are some of the same drops from the full firewall log

Why is this traffic getting blocked?

Key concern is the destination address.
Why is this traffic going to the network address?
This is an Android device so there  little hope of finding a rational adult there to assist.
I'm just hoping I can find some answers here.

This thread was automatically locked due to age.
Parents Reply Children
  • I repeat my question: what are your interfaces / zones in relation to those interfaces

    What we know now: you have an interface "WLAN1" with and I guess this should have /16 as mask.

    The you have "External WAN" with maybe a public address from your ISP

    rfcat_vk asked for an "Internal" LAN interface, which is normally used for a cabled network.

    If traffic from to is dropped, then you have something misconfigred with your subnet masks.

    With a /16 mask, and awould be in the same net and not cause any drops. Are these devices on the same interface?

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.