Interface tracking / reachablity check in HA

Hi Emre,

While configuring HA, you will get two options to select, 

1. Select a preferred Master
2. Select a backup interface

Preferred master: Here you can define a designated master node by selecting a node from the drop-down list. In case of a failover, the selected node will not stay in Slave mode after the link recovers but instead will switch back to Master mode.

Backup interface: To prevent that both master and slave become master at the same time (master-master situations), for example, because of a failure of the HA synchronization interface or an unplugged network cable, a backup heartbeat interface can be selected. This additional heartbeat interface can be any of the configured and active Ethernet interfaces (not Ethernet Bridge or Ethernet VLAN). If a backup interface is selected, an additional heartbeat signal is sent via this interface in one direction from the master to the slave to make sure that the master-slave configuration stays intact. If the master-slave connection is disabled and the backup interface becomes involved, the administrator will receive a notification informing that one of the cluster nodes is dead. However, this option is of no effect on slave systems, so you can leave it unconfigured.

Thanks

Hi sachingurung,

Thank you for your explanation. Probably I could clearly explain my problem because your explanation is not a solution for me.

I have 2 Sophos and their both E0 ports are conencted to 2 swtiches (for example).

Let's say 1st sophos is master. Meanwhile, if switch 1 is down, 1st sophos is still Master which I don't want. I want to track E0 so that when this port is down (or lost reachibility to switch 1), I want the other pair of Sophos bacame Master. 

I hope it is better explanation.

Thank you

In that case, go to Interfaces & Routing > Interface > Hardware > Eth0; select the HA Link Monitoring on the interface.  In case of a link failure, as stated by you, a takeover will be triggered. It is not recommended because it can cause unnecessary failures at the time. Also, if a configured interface is not always connected (e.g. management interface) please disable HA link monitoring for the corresponding interface. Otherwise all HA nodes will stay in status UNLINKED.

Thanks

In that case, go to Interfaces & Routing > Interface > Hardware > Eth0; select the HA Link Monitoring on the interface.  In case of a link failure, as stated by you, a takeover will be triggered. It is not recommended because it can cause unnecessary failures at the time. Also, if a configured interface is not always connected (e.g. management interface) please disable HA link monitoring for the corresponding interface. Otherwise all HA nodes will stay in status UNLINKED.

Thanks

Thank you for your answer again. It was already enabled on all interfaces and it was leading the problem with HA status. After I disable HA link monitoring in unused ports, it seems it is working now.