Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 7 replies
  • Answers 1 answer
  • Subscribers 5 subscribers
  • Views 5964 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Port forwarding

BrianKaaya

 Dear community,

I have 2 different databases on our network I want to be accessible remotely to staff once they are out of the hospital. The first one A is running on IP 192.168.1.A , the other is B at 192.168.1.B and my public IP is 160.242.143.153. I have gone ahead to have a address point to these respectful IPs say database1.ug and database2.ug so users dont have to worry about remembering the IP addresses to get to these databases.

Can someone assist me how to configure my firewall and DNAT to accept access to these database while away from the hospital.

Thanks and regards

Brian 



This thread was automatically locked due to age.
Parents
  • 0

    Network Protection / NAT / New NAT Rule

    For traffic from: Any

    Using service: create new service definition pointing to port#

    Going to: External (WAN)

    Change the destination to: database1.ug or database2.ug

    Automatic firewall rule: check

     

    Hope that helps

  • 0 in reply to PatrickLee

    Thanks you  PatricLee

    The thing is I need to use this rule for 2 databases simultaneously at any time. One database uses numerous ports 

    • openmrs_port: 8050
    • bahmni_reports_port: 8051
    • bahmni_lab_port: 8052
    • bahmni_erp_connect_port: 8053
    • pacs_integration_port: 8054
    • openerp_port: 8069
    • dchm4chee_ports: 8055, 8056
    • event_log_service_port: 8057

    and the other has apache running ports 80,443; tomcat 8080 so I am very confused which to run where exactly.

  • 0 in reply to BrianKaaya

    Hi Brian,

    As suggested b PatricLee follow the same steps and add a custom service definition which consists of all the ports you need to forward.

    Thanks

    Sachin Gurung
    Team Lead | Sophos Technical Support
    Knowledge Base  |  @SophosSupport  |  Video tutorials
    Remember to like a post.  If a post (on a question thread) solves your question use the 'This helped me' link.

  • 0 in reply to sachingurung

    Dear Sachingurung,

    Thank you for your note. I have actually tried and been successful with the advice from PatrickLee but that gets me to view only one of the databases. I would love some help on how to actually do this step by step as I have failed otherwise.

  • 0 in reply to BrianKaaya

    create new service definition

    Name: whatever you want for ex. Database Protocol

    Type of definition: UDP/TCP

    Destination port: 8050:8069

    Source port: 1:65535

    Comment: Use for Database

    Put the new service definition in your DNAT rule

Reply Children
  • 0 in reply to PatrickLee

    Hello Brian, Since you have one successfully gained access to one database by creating the needed configuration, it should be possible for you to use the "clone" feature for each part of your configuration. Changing the IP addresses and descriptions accordingly, then save and test?

Unfiltered HTML